To produce a strong, uniform weld bead:
-
Maintain a steady hand to ensure consistent bead shape.
-
Control heat input and travel speed: use more heat or slower travel for thick plates to ensure penetration; use less heat or faster travel for thin plates to prevent burn-through.
-
Control arc starting and stopping to ensure reliable fusion and joint strength.
-
Fill the end crater before extinguishing the arc. An unfilled crater may cause stress concentration and cracking.
Welding quality depends on proper technique, experience, and consistent operation.
Weld Bead Connections
-
Tail-to-Head: Start the new bead at the end of the previous bead. This is the most common method.
-
Head-to-Head: Strike the arc slightly ahead of the previous starting point, move back to overlap it, then weld in the opposite direction.
-
Tail-to-Tail: Strike the arc from the opposite end and weld toward the previous bead’s end. Slow down to fill the crater, then move forward briefly before stopping.
-
Head-to-Tail: End the new bead at the start of the previous bead. Remelt and level the overlap before quickly extinguishing the arc.
Arc Termination Methods
-
Circular Motion: Move the electrode in small circles until the crater is filled. Suitable for thick plates.
-
Repeated Arc Breaking: Repeatedly extinguish and restrike the arc until the crater is filled. Suitable for thin plates and high-current welding, but not recommended for basic low-hydrogen electrodes due to porosity risk.
-
Backstep Method: Pause at the weld end, adjust the electrode angle, and weld backward briefly. Suitable for basic low-hydrogen electrodes.